13
Note: If you want to manually program the Sensor Counts, push and hold the Enter Button at the back of
the FL-2 (with the Sensor Counts displayed and not blinking) until the thousands digits starts to blink.
To increase the count of the blinking digit, move the Selector Switch from the center position to the
right.
To decrease the count of the blinking digit, move the Selector Switch from the center position to the left.
To blink the next digit to the right, tap the Enter Button on the back of the FL-2.
To exit the manual programming of the Sensor Counts, lock the
Sensor Counts into the display and stop the blinking of a digit, push
and hold the Enter Button for 3 seconds.
9. To advance to the next calibration point, move the selector switch to
the left position, push and hold the Enter Button on the back of the unit
until you see “CAL2” in the display. All of the calibration data for
calibration point 1 has been stored to permanent memory.
10. Fill the tank to the fuel level indicated on your calibration chart for the
next calibration point.
11. Place the Selector Switch to the center position. The FL-2 will display the last programmed fuel level for
this calibration point. The display will show something like “P015” or
maybe “F015”. A “P” would indicate this is a partial fuel level (not the
full fuel level). An “F” would indicate this is the full fuel level for the
tank and the last cal point. The "015" is the fuel level for this cal point.
12. To program (change) the fuel level for this calibration point, push and
hold the Enter Button on the back of the FL-2 for 3 seconds. The far
left letter (“P” or “F”) will be blinking. To change this letter, move the
selector switch to the left or right.
If this calibration point is for a partial fuel level (not the full fuel
level), select “P”. If this calibration point if for the full fuel level (the last cal point) select “F”.
Note: The programmed fuel level must increase for each calibration point.Note: The programmed fuel level must increase for each calibration point.
Note: The programmed fuel level must increase for each calibration point.Note: The programmed fuel level must increase for each calibration point.
Note: The programmed fuel level must increase for each calibration point.
To increase the count of the blinking digit, move the Selector Switch from the center position to the
right.
To decrease the count of the blinking digit, move the Selector Switch from the center position to the left.
To blink the next digit to the right, tap the Enter Button on the back of the FL-2.
To exit the programming of the fuel level for this calibration point and stop the blinking of a digit, push
and hold the Enter Button on the back of the FL-2 for 3 seconds.
CAL 2CAL 2
CAL 2CAL 2
CAL 2
P015P015
P015P015
P015
(25 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels